Home › Forums › Bows and Equipment › Saw Blade Trade Point

Viewing 4 reply threads
  • Author
    Posts
    • Bounty Hunter
        November 2, 2011 at 12:04 am
        Post count: 149
        #4260

        Finished the prototype of the Saw Blade Trade Points I’m working on and it is really close to what I was looking for in a head. It came out finished at 206 grains and I was shooting for 200. I cut this one out of a Black & Decker circular saw blade. Going to go and try and tested it here before dark and will try and post the video sometime later.

      • William Warren
        Member
          November 2, 2011 at 1:30 am
          Post count: 1384
          #28869

          Looks great! What are you cutting them out with?

          Duncan

        • David Petersen
          Member
            November 2, 2011 at 1:34 am
            Post count: 2749
            #28874

            I have the same compliment, and same questions, as Duncan. And any idea the hardness of the steel?

          • Bounty Hunter
              November 2, 2011 at 2:42 am
              Post count: 149
              #28912

              Guys I’m using a 4″ Angle Grinder with a cutting disk for the initial cuts and then the final shaping and sharping is all done with a file. Not sure of the hardness Dave, but they are tough. Here is a video of the test I did on this one.

              http://www.youtube.com/watch?v=GarIU5CHnr4

            • skifrk
                November 2, 2011 at 8:58 pm
                Post count: 387
                #29750

                Bounty Hunter that is really cool craftmanship an done day when I have the room in the garage I will have to try.

            • Author
              Posts
            Viewing 4 reply threads
            • You must be logged in to reply to this topic.