Here’s something you might want to try in the future. Instead of gluing the insert in use a plastic sandwich bag as a shim. Place the bag over the end of the shaft and insert the insert, it should go in fairly tight and quite often I have to push down on the shaft with the insert on solid ground to seat it. They won’t come out if using a bag or foam target, hard foam like a 3d target they might. Then you can just take a pair of pliers and pull them out by gripping the field point. Trim the shaft, reinsert and away you go.
Reply To: Remove inserts from carbon shaftsDan Jackowiak2016-12-25T06:41:35-07:00