Home Forums Bows and Equipment Making bow quivers Reply To: Making bow quivers

archer38
    Post count: 242

    This is my home made moccasin quiver. An old pair of slippers was sacrificed in the making of this quiver. They were mocs with a smooth sole and slight heel.

    The top half is both tongue pieces sewn together and filled with spray foam. There is also a small “u” shaped bracket that sticks through the back side to strap to the limb. The bottom is made from the heel of the slipper. I cut a slot in it so as to fit snug over the limb and drilled holes along the rounded edge. Then I cut slots into the holes to snap the arrows in. They fit very snug and do not slip.

    Both pieces tie onto the bow with lacing. I hope to improve this design with a velcro strap one for easier install/removal.